BM5A MKll Users manual
IMPORTANT SAFETY INSTRUCTIONS The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
TABLE OF CONTENTS INTRODUCTION Important Safety Instructions & Certificate of conformity . . . . . . . . . . . .a Table of Contents . . . . . . . . . . . . . . . . .3 Introduction . . . . . . . . . . . . . . . . . . . . . .4 OPERATING Rear Panel - Overview . . . . . . . . . . . . .5 Setting Up . . . . . . . . . . . . . . . . . . . . . .6 Indicators . . . . . . . . . . . . . . . . . . . . . . .7 Positioning . . . . . . . . . . . . . . . . . . . . . .7 MISCELLANEOUS Troubleshooting . . . . . . . . . . . . .
INTRODUCTION OVERVIEW - REAR PANEL Correct setup and connections is essential to achieve optimal performance from your monitors. Please follow the instructions on the following pages. Congratulations on your new Dynaudio Acoustics BM5A MKll. BM5A MKll is a proud extension of its predecessor BM5A with improved performance on virtually every level.
SETTING UP 1/2. Power On/Off switch/AC Power In Before switching on, make sure Mains Voltage matches your areas Mains Voltage specification. Replace fuse only with the fuse-type marked on the rear-panel label. 3. Balanced analog Input Audio Input is via a female XLR connector. The Input is electronically balanced with following connections. The connections are printed on the rear for easy reference. 0 + - If your signal source is unbalanced, usually the unused pin is connected to ground.
MISCELLANEOUS Troubleshooting If Power LED lights green and no sound, check your input signal f.ex. by switching speakers. If power LED does not light at all and no sound, check the fuse. If replaced and still no sound contact your Dynaudio Acoustics Dealer. If protection LED lights red check the temperature of the heat sink. If it feels hot turn off the speaker and wait for some 10 minutes to allow the amplifier to cool off. Turn it on again.
