Owner's Manual

18
Connecting a single subwoofer
1. To connect the SAT/SUB input:
From the preamplier output of your
processor/receiver, PC or media
player (often marked as Pre Out or
Front Out) connect a stereo RCA
cable to the subwoofer SAT/SUB
Input.
This signal should not be already
processed by the processor/receiver.
Please pay attention to the settings of
your processor/receiver.
2. To connect the LFE channel:
From the processor or receiver’s
low-level (not a speaker output)
subwoofer output (often marked
as “subwoofer out”, “Sub out” or
“LFE”), connect a mono RCA-to-
RCA cable to the subwoofer input
SUB I/O - LFE/Slave IN.
Please pay attention to the settings of
your processor/receiver.
Set the MODE switch to LFE.
Note
You also can use both connection
types. Both signals will be
combined in the Sub3 and routed
accordingly.
This allows the Sub3 to reproduce
both the LFE channel information
as well as the bass range of the
connected satellite speakers
ON AUTO
GAIN PHASEPOWER
SUB LowpassSAT Highpass
SAT/SUB Input SAT Output
LFE / Slave IN OUT
Min Max
50Hz 150Hz
0° 180°
LEFT
RIGHT
SUB I/O To Slave
LFE Slave
60HzFlat 80Hz
2. LFE/SUB Out1. Front Out/Pre Out
n
e
d
c
e
n
a
ve