Owner's Manual

17
dynaudio.com/focusxd Connecting the analog signal source / Operating the loudspeaker without controlling the volume
Connecting the analog signal
source
The loudspeakers can also output signals
from an analog signal source. The signal
source is connected to the analog inputs.
1. Connect the left analog output from
the signal source to the analog
input (Analog Audio IN) on the left
loudspeaker.
2. Connect the right analog output
from the signal source to the analog
input (Analog Audio IN) on the right
loudspeaker.
3. Operate one loudspeaker as master
and the other as slave by setting the
respective switch (Channel Mode)
correspondingly on the rear side of the
housing. The assignment of master and
slave is irrelevant.
Operating the loudspeakers
without controlling the volume
You can also operate the loudspeakers
without controlling the volume yourself.
The ampliers integrated into the
loudspeakers function as a power
amplier; volume is controlled via the
source signal (e.g. pre-amplier).
1. Connect the left analog output from
the signal source to the analog
input (Analog Audio IN) on the left
loudspeaker.
2. Connect the right analog output
from the signal source to the analog
input (Analog Audio IN) on the right
loudspeaker.
3. Set the Channel Mode switch on the
back side of the housing to External.
Connecting the analog signal source.
High sound pressure levels
In the External operating mode, signals
are amplied at the maximum. Connecting
a signal source with an uncontrolled or
maximum level can harm your hearing and
cause damage to the components.
Ź
Only connect controllable signal
sources.
Ź
Before switching on the loudspeakers,
turn down the volume for the signal
source using its volume control.