Owner's Manual

Owner’s Manual Focus XD
20
Selecting inputs on the loudspeakers / Adjusting the volume
Ź
Press the DIRECT button on the
remote control. The loudspeakers
toggle between the analog and digital
input if the corresponding signal
sources are connected.
Selecting the Hub or Connect inputs
Optionally, the loudspeakers can also be
operated with a Dynaudio Hub or Connect
box. For details on operation via Hub or
Connect, please refer to the Connect
Owner’s Manual.
Selecting a Hub or Connect (HUB)
Ź
Press HUB A, B, or C on the remote
control. The chosen Hub or Connect is
selected as the signal source.
Selecting an input on the Hub or
Connect (INPUT)
Ź
Press INPUT 1, 2, 3, or 4 on the
remote control. The selected signal
source will be played back.
Night Mode
Ź
Briey pressing the MOON button
on the remote control will activate
Night Mode. When in Night Mode, the
status LEDs will only be lit up when
the speaker is receiving commands
from the remote control. After a few
seconds, the LEDs will turn off. Press
the MOON button again to disengage
Night Mode.
Fixed Volume
Ź
Press and hold the MUTE button to
set the volume to a xed, high level.
To disengage the Fixed Volume mode,
simply change the volume level using
the Volume +/- buttons on the remote.
Disabling/Enabling Autosense
Ź
In normal operation, the Focus XD will
go to stand-by if it does not sense an
incoming signal. Hold the ”Direct In”
button on the remote for 5 seconds,
to disable or enable Autosense. The
status LED will blink once for enabling,
and twice for disabling Autosense.
Note that when Autosense is off, the
speaker will remain On, until the user
actively sets the speaker in Stand-By
using the Off button.
Change the volume by pressing the
VOLUME button on the remote control.
Ź
Press to turn the volume up.
Ź
Press to turn the volume down.
Muting the loudspeakers
Ź
Briey pressing the MUTE button on
the remote control will mute or unmute
the selected loudspeaker.
Selecting inputs on the
loudspeakers
Adjusting the volume
Note
If loudspeakers are operated in hub
mode in different zones, the volume
is controlled separately. For details
on operation via the Xeo hub,
please see the Xeo owner’s manual.