Owner`s manual

Before operation
6  BM14SII
(10)SAT/SUB(input)
Inputforfullbandwidth signal.Thissignal willbeprocessed
accordingto the Highpass setting and provided at theSAT/
SUBoutput.
(11) LFE
 –LFE/Slave:inputforLFEsignal
 –Slave:outputtonextsubwooferifinstalled
Terminal pinout (sockets 9, 10 and 11)
1 = 0
2 = +
3 = –
Connecting the subwoofer
4. Getting started
6 Dynaudio Acoustics BM14S
Connecting the subwoofer
Subwoofer inputs
The BM14S provides two different signal inputs:
LFE/Slave
This input allows the LFE (Low Frequency Effect) channel to be connected.
The signal is:
• reproduced by the subwoofer
• routed to the Slave output for a second subwoofer to be connected.
The Lowpass control has no impact on this input.
SAT/SUB
This input allows the connection of a full bandwidth signal.
The signal is:
• reproduced by the subwoofer,
• routed to the SAT/SUB output terminals. Low frequencies are cut-off according to
the Highpass setting,
• routed to the Slave output for a second subwoofer to be connected. High
frequencies are cut-off according to the Lowpass setting.
CAUTION
Damage due to improper connections!
Improper connections may damage the device.
Set the mains power switch to OFF before connecting the BM14S.
Only switch the subwoofer on (mains power switch to ON) after all connections
and set up steps have been properly completed.
Highpass
Lowpass
+
Gain
+
LFE/Slave
Mode
Phase
+
SAT/SUB
SAT/SUBSlave
CAUTION
Damage due to improper connections!
Improperconnectionsmaydamagethedevice.
 –SetthemainspowerswitchtoOFFbeforeconnectingthe
BM14SII.
 –Onlyswitchthesubwooferon(mainspowerswitchtoON)
afterallconnectionsandsetupstepshavebeenproperly
completed.
Subwoofer inputs
TheBM14SIIprovidestwodifferentsignalinputs:
LFE/Slave
ThisinputallowstheLFE(LowFrequencyEffect)channelto
beconnected.Thesignalis:
 –reproducedbythesubwoofer
 –routedtotheSlaveoutputforasecondsubwoofertobe
connected.
The Lowpass control has no impact on this input.
SAT/SUB
This input allows the connection of a full bandwidth signal.
Thesignalis:
 –reproducedbythesubwoofer,
 –routedtotheSAT/SUBoutputterminals.Lowfrequencies
are cut-off according to the Highpass setting,
 –routedtotheSlaveoutputforasecondsubwoofertobe
connected. High frequencies are cut-off according to the
Lowpass setting.