Specifications

Operation
Dynaudio SUB 300/500 9
Operating the subwoofer
Fitting the remote control battery
Before the DSC 1 remote control can be used, it needs to be fitted with the battery cell
that comes separately packed with the remote control.
To replace and insert a battery:
1. Release the battery tray by pushing its locking tab on the back of the remote
sideways with your nail and at the same time slide the tray out of the remote
control battery compartment.
2. Remove the exhausted battery and dispose of properly. Insert a new battery in the
battery tray: observe correct polarity (both battery and tray are marked with a “+”).
3. Slide the battery tray into the battery compartment until the locking tab clicks into
place. Make sure it is inserted the correct way up, the tray will slide into place
easily, do not use force.
Note
• The battery will last a considerable time, depending on frequency of use. When you
notice that the subwoofer doesn't always respond or only from a very close range
to commands from the remote control, it is likely the battery is exhausted and will
need replacing.
• Use only CR2025 button cell batteries to replace the original battery with. These
are readily available from most electrical stores.
• Do not leave the remote control in high temperature environments (such as in
direct sunlight) as it can possibly result in deformation of the remote's case.
Operation
1.
2.
3.