Manual

36
cables with 4 mm banana connectors, you need to
connect only the two plugs of each loudspeaker
cable with the two associated clamps and the screw
cover of the clamp should be turned in a clockwise
direction. If loudspeaker cables with cable lugs are
used, then the screw head on every clamp must be
loosened in an anticlockwise direction, the cable
lug pushed under it and the screw cover tightened
in a clockwise direction. If the loudspeaker cables
are to be attached without connectors, remove a
piece of the insulation about 1 cm long from each
end of the loudspeaker wire. Twist the bare wire in
order to prevent short circuits. Turn the knob of the
loudspeaker clamp in anticlockwise direction to loo-
sen it and feed the bare wire end into the clamp
hole now exposed. Now turn the knob in a clockwi-
se direction to secure the wire in the loudspeaker
clamp. Make sure that the screws are tight.
Connection of the mains cable
Connect the power plug to a mains socket which is
supplied with an appropriate voltage (230 V/50 Hz).
Do not switch the device on until after you have
adjusted the volume control (10) in anticlockwise
direction to the minimum volume.
CONNECTION AND PLACING INTO OPERATION
E-SA18 MKBT_A6_quer_RZ_Okt.qxp_Layout 1 30.09.21 09:47 Seite 36