Pest Control Equipment User Manual

Control Panel Interface Installation and User Guide
CHAPTER 1
Introduction
1-4
REMOVING THE PIT COVERS
Dynojet recommends using a T30 Torx driver (Snap-On PFTx30E) or a hardened
5/32-inch hex driver (Snap-On Fa5E), for dynos with serial numbers lower than
2030152, to remove the 1/4-inch screws. A standard allen key may round off in the
shallow screw head.
1 Remove the four 3/8-16 x 1/2-inch button-head flange screws securing the right
side drum cover to the drum module and set aside.
2 Remove the four 1/4-20 x 1/2-inch button-head flange screws securing the right
side drum cover to the drum guard bracket and set aside.
3 Remove the cover and set aside.
Figure 1-2: Right Side Drum Cover