Pest Control Equipment User Manual

Control Panel Interface Installation and User Guide
CHAPTER 1
Routing Cables
1-14
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ROUTING CABLES
For the following instructions, we will show the support arm and control panel
mounted on the right side of the dyno with the Control Panel Interface (CPI) and
dyno electronics on the left side of the dyno.
The CPI and dyno electronics must be placed near the conduits in the pit.
Be sure to keep the power and communications cables in different pit conduits. For
the following instructions, we will designate the pit conduits as shown.
Figure 1-11: Pit Dyno Room Layout
PD02
6
dyno
electronics
control panel
interface
(CPI)
control panel
junction box
monitor support and tray
route communications cables
in designated conduit
route power cables
in designated conduit