User Guide

Control Panel Interface Installation and User Guide
CHAPTER 1
Introduction
1-6
REMOVING THE CONTROL PANEL INTERFACE COVER
The Control Panel Interface (CPI) comes wired and ready to install. Should you need
to re-route the cables so they come out a different side of the box, use the following
instructions to access the CPI box.
1 Turn off the power to the dyno. Refer to “Connecting and Disconnecting Power
to the Dyno” on page 1-3 for more information.
2 Remove the eight button-head screws securing the cover and set aside.
3 Remove the cover and set aside.
4 Open the front panel to access the breakers and Breakout board.
Figure 1-5: Accessing the CPI
PD027
cover
front panel access