Manualshelf

User Guide

ManualsBrandsDynojet Research ManualsMicrophone200iP
11121314151617181920
Control Panel Interface Installation and User Guide
CHAPTER 1
Battery
1-8
INSTALLING THE BATTERY
The model 200ip/250ip dyno is designed to carry a group 24 deep cycle discharge
series battery for operating the built in starter. This battery is not included with your
dyno. You will need to provide this battery.
For more information on battery requirements and battery chargers refer to “Battery
Requirements” in Chapter 1 of the Model 200ip/250ip Motorcycle Pit Dynamometer
Installation Guide.
1 Locate the red battery cable on the inside of the dyno.
2 Place the battery in the battery carrier on the inside of the dyno so the red cable
can reach the positive (+) post on the battery and the black battery cable can
reach the negative (-) post.
3 Secure the battery to the tray with the battery hold-down.
4 Refer to page 1-23 for instructions on routing and connecting the battery cable.
Figure 1-6: Install the Battery
battery