User Guide

Control Panel Interface Installation and User Guide

CHAPTER 1

Blower Mounts, Support Arm, and Junction Box

1-12

INSTALLING THE ARMS AND MONITOR TRAY

1 Insert a plastic cap in both ends of each arm.

2 Place a poly washer around the pin of the first arm and insert the pin into the

support arm.

3 Place a poly washer around the pin of the second arm and insert the pin into the

first arm.

4 Place a poly washer around the pin of the tray and insert the pin into the second

arm.

Note: The monitor tray is an optional accessory. If you did not order a monitor

tray, skip this step.

5 Check for clearance between the monitor arm and motorcycle, walls, ceiling, etc.

Note: Dynojet does not recommend placing the computer CPU on the

monitor/keyboard tray since vibration can cause damage to the computer.

Figure 1-9: Install the Monitor Tray

second arm

poly washer

first arm

monitor tray

support arm

poly washer