User Guide

CONTROL PANEL INTERFACE INSTALLATION
Blower Mounts, Support Arm, and Junction Box
Version 1 Control Panel Interface Installation and User Guide
1-13
INSTALLING THE HIGH PRESSURE BLOWERS
The high pressure blowers are an optional accessory. If you did not order the high
pressure blowers, skip these instructions.
Repeat the following steps for each blower assembly.
1 Place two 1/4-inch thick poly washers around the pin on the blower mount.
Note: Only use one 1/4-inch thick poly washer with the blower mount installed
with the support arm.
2 Place the lower blower arm over the blower mount pin.
3 Place a 3/8-inch thick metal washer on top of the lower blower arm.
4 Secure the lower blower arm using the clamp lever.
5 Place a 1/8-inch thick poly washer around the pin on the upper blower arm.
6 Insert the pin on the upper arm into the lower arm.
7 Place a 1/8-inch thick poly washer around the pin on the blower assembly.
8 Insert the pin on the blower assembly into the upper arm.
Figure 1-10: Install the High Pressure Blowers
blower
assembly
poly washer
upper arm
poly washer
lower arm
poly washer
clamp lever
blower assembly
blower mount
metal washer
only one 1/4-inch
poly washer