User Guide

CONTROL PANEL INTERFACE INSTALLATION
Routing Cables
Version 1 Control Panel Interface Installation and User Guide
1-15
ROUTING THE CONTROL PANEL AND PENDANT CABLES
1 Route the control panel cable (P/N 76951502) from the CPI through the
designated communications pit conduit, through the pit, and out of the pit as
shown.
2 Route the pendant cable from the dyno electronics through the same conduit and
along the same path as the control panel cable.
Note: Be sure to keep the power and communications cables in different pit
conduits.
3 From the pit, route both cables through the junction box.
Figure 1-12: Route the Control Panel and Pendant Cables
PD02
8
CPI
dyno
electronics
route communications cables
in designated conduit
route power cables
in designated conduit