User Guide

CONTROL PANEL INTERFACE INSTALLATION
Routing Cables
Version 1 Control Panel Interface Installation and User Guide
1-19
ROUTING THE BLOWER CABLES
The high pressure blowers are an optional accessory. If you did not order this
accessory, skip these instructions.
1 Route each blower cable (P/N 76950315) from the CPI through the designated
power pit conduit, through the pit, and out of the pit as shown.
Note: Be sure to keep the power and communications cables in different pit
conduits.
2 From the pit, route both cables into the junction box.
3 Attach the two blower connectors to the junction box using 4-40 screws.
4 Connect the cables from each blower to the connectors on the junction box.
Note: There is an extension cable (P/N 76950317) for the blower furthest from
the junction box.
Figure 1-17: Route Blower Cables
extension cable
connectors
CPI
dyno
electronics
route power cables
in designated conduit