User Guide

Control Panel Interface Installation and User Guide
CHAPTER 1
Routing Cables
1-20
ROUTING THE MOTORIZED CARRIAGE AND WHEEL CLAMP CABLES
The wheel clamp is an optional accessory. If you did not order this accessory, skip any
steps referring to the wheel clamp cable.
Refer to Appendix B for motorized carriage and wheel clamp installation instructions.
1 Route the motorized carriage cable (P/N 76950314) from the CPI through the
designated power pit conduit, through the pit, and out of the pit as shown in
Figure 1-20.
2 Route the wheel clamp cable (P/N 76950313) from the CPI through the same
conduit and along the same path as the motorized carriage cable.
Note: Be sure to keep the power and communications cables in different pit
conduits.
3 From the pit, route both cables through the junction box as shown in Figure 1-20.
4 Press each cable into the cable track.
Note: The cable must be pressed into the cable track before installing the cable
track ends and brackets.
5 Snap the cable track ends onto the cable track as shown below.
6 Secure the junction box cable track bracket to the cable track end using two
screws and nuts.
7 Secure the wheel clamp cable track bracket to the cable track end using two
screws and nuts
Figure 1-18: Install Cable Track Ends and Brackets
junction box cable
track bracket
wheel clamp cable
track bracket
cable track end
cable track end