User Guide

Control Panel Interface Installation and User Guide
APPENDIXB
Motorized Carriage
B-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MOTORIZED CARRIAGE
The motorized carriage allows you to easily adjust for various wheel bases distances
with the press of a button.
Refer to “Using the Motorized Carriage” on page 2-5 for more information on using
the motorized carriage.
INSTALLING THE MOTORIZED CARRIAGE
1 Insert the coupler jaw on the carriage screw making sure the inside of the coupler
jaw is flush with the end of the carriage screw.
2 Secure the coupler jaw with the set screw.
3 Secure the motor mount to the carriage using two 1/4-20 x 1-inch bolts and two
1/4-inch lock washers. The motor mount is installed in front of the flange bearing.
Note: The flange bearing must be facing so the grease zerk is accessible (facing
down).
Note: Dynojet recommends using a 1/4-inch ratchet drive with an extension and a
7/16-inch shallow socket to secure the flange bearing bolts.
Note: If the motor mount is already installed, skip this step and continue.
Figure B-1: Install the Motor Mount
motor mount
flange bearing
coupler jaw