User Guide

CONTROL PANEL INTERFACE INSTALLATION
Introduction
Version 1 Control Panel Interface Installation and User Guide
1-3
CONNECTING AND DISCONNECTING POWER TO THE DYNO
Many instructions in this guide will require you to connect or disconnect the power to
the dyno as part of the installation process. Use the following steps to connect and
disconnect power to the dyno.
Always turn the power off when connecting and disconnecting cables.
1 Use the main breaker to turn power on and off to the dyno.
The main breaker is located inside the power distribution assembly.
2 Disconnect the power plug to ensure all power has been removed from the dyno
before performing certain installation procedures.
Figure 1-1: Main Breaker Location
PD02
5
main breaker
power plug
breakout board