Motorcycle Accessories User Manual

TORQUE MODULE INSTALLATION
Torque Module Installation
Version 4 Torque Module Installation and User Guide for Model 250 Dynamometers
1-5
6 Secure the Torque Module to the dyno electronics with the plastic tie straps (one
on each side).
7 Attach the 9-pin connector on the load cell cable to the front of the Torque
Module and tighten down the screws.
8 Attach the power cord to the dyno electronics and turn the power switch on.
The green LED light on the Torque Module should now be on.
Figure 1-3: Attach Torque Module and Load Cell Cable
load cell cable and port
green LED light
tie strap
torque module