Pest Control Equipment User Manual

CONTROL PANEL INTERFACE INSTALLATION
Blower Mounts, Support Arm, and Junction Box
Version 1 Control Panel Interface Installation and User Guide
1-11
INSTALLING THE BLOWER MOUNTING PLATE, SUPPORT ARM, AND JUNCTION BOX
The high pressure blowers are an optional accessory. If you did not order high
pressure blowers, you will not need to install the blower mounting plates.
1 Secure each blower mounting plate to the pit floor using four 3/8 x 1-inch bolts
and 5/16-inch washers.
Note: The blower mounting plate is secured under the support arm.
2 Secure the support arm and junction box to the pit floor using four 3/8 x 1-inch
bolts and 5/16-inch washers.
Note: The support arm can be mounted on either side of the dyno.
Figure 1-8: Install Blower Mounting Plates, Support Arm, and Junction Box
PD039
support arm
blower mount
junction box
blower mount
(under support arm)