User Guide

Power Carriage Installation Guide
POWER CARRIAGE
Installation
4
2 Using a 5/32-inch allen wrench, loosen the two set screws in the lock collar and
remove it from the screw shaft.
3 Using a 7/16-inch wrench, remove the two bolts securing the flange bearing.
4 Pry the flange bearing from the carriage screw shaft with a flat screwdriver and set
aside.
Note: Clean the shaft with a fine grit emery cloth to remove any remaining thread
lock residue. This will make it easier to slide the motor assembly and flange
bearing on the shaft.
Figure 2: Remove the Flange Bearing
INSTALLING THE POWER CARRIAGE
1 Remove the two button-head screws securing the aluminum cover to the motor
mount assembly and set aside.
Figure 3: Remove the Aluminum Cover
set screw on lock collar
(only one visible)
bolts
shaft
flange bearing
button-head screws
aluminum cover
motor mount assembly