User Guide

INSTALLATION GUIDE

Installation

Version 2 Power Carriage Installation Guide

2 Slide the motor mount assembly and flange bearing, removed earlier, over the

screw shaft. Make sure the flex coupling is on the shaft.

Note: The flange bearing must be facing as shown in Figure 4 so the grease zerk is

accessible.

3 Secure the motor mount assembly and flange bearing to the carriage using two

1/4 x 1-inch bolts and lock washers.

Note: Dynojet recommends using a 1/4-inch ratchet drive with universal joint and

a 7/16-inch shallow socket to secure the flange bearing bolts.

4 Using a 1/8-inch allen wrench, tighten the flex coupling set screw.

Figure 4: Install the Motor Mount Assembly

motor mount

assembly

screw shaft

flex coupling set screw

flange bearing bolts

grease zerk

flex coupling

flange bearing