User's Manual

DynoWare EX+ Upgrade For The Model 248 Dynamometer
DYNOWARE EX+ UPGRADE
Remove The Original Hardware
4
REMOVING THE CONTROL BOX
1 Shut off and release the air pressure to the control box.
2 Disconnect all cables and air hoses from the control box.
3 Remove the control box from the wall.
Figure 2: Control Box
4 Disconnect the data acquisition cable from the dyno and remove the cable.
5 Disconnect the air hose and remove the fitting from the top of the air canister on
the right hand side of the dyno.
Note: Leave the air hose with the dyno as it will be used later.
Figure 3: Disconnect Cable and Air Hose
remove data
acquisition cable
remove air hose
air canister