User's Manual

INSTALLATION GUIDE
Installation
Version 2 Monitor Arm Installation Guide
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
This articulated arm and platform supports the monitor, keyboard, and mouse in a
convenient position for operation while seated on the motorcycle. The arm can be
mounted on either side of the dynamometer.
INSTALLING THE MONITOR ARM BRACKET
1 Drill a 1/2-inch hole through the aluminum deck plate as shown in Figure 1. Use
the existing hole under the deck plate as a guide.
2 Fasten the top of the monitor arm bracket to the dyno using a 3/8-inch bolt,
3/8-inch lock washer, and 3/8-inch flat washer.
Note: Do not tighten.
3 Secure the bottom of the bracket to the dyno using two 1/2-inch bolts,
four 1/2-inch washers, two 1/2-inch lock washers, and two 1/2-inch nuts.
4 Fully tighten all three bracket bolts.
Figure 1: Install the Monitor Arm Bracket
monitor arm bracket
drill hole
3/8-inch bolt
1/2-inch bolt