User's Manual

Torque Module Installation and User Guide for Model 250 Dynamometers
CHAPTER 1
Load Cell Installation
1-10
REPLACING THE HOOD
1 Replace the hood on the dyno leaving it propped up. Secure the key switch, if
present, and connect the battery.
2 Lower and secure the hood using the four bolts you removed earlier.
Figure 1-12: Replace the Hood
3 Secure the hood clamps to the brake using the two bolts you removed earlier.
4 Replace the brake cover and secure using the four bolts you removed earlier.
Figure 1-13: Replace the Brake Cover and Hood Clamps
key switch
brake cover
hood clamps