User Manual

EDDY CURRENT BRAKE INSTALLATION
Eddy Current Brake
Version 8 Eddy Current Brake Installation Guide
1-11
INSTALLING THE DYNO SHAFT COUPLER
1 Replace the existing set screw in the key way of each coupler with the thread-lock
set screws provided.
Note: Replace the dyno shaft coupler set screw before installing the coupler on
the shaft.
Figure 1-14: Replace the Coupler Set Screws
2 Insert the key into the keyway.
3 Slide the coupler over the key on the axle.
Note: Do not tighten the set screw in the coupler.
Figure 1-15: Install the Dyno Shaft Coupler
dyno shaft coupler
key way
key way
eddy current brake coupler
set screw
set screw
coupler
key way