Installation Guide User Manual

Motorcycle Dynamometer Installation Guide
CHAPTER 3
Power Carriage
3-40
5 Secure the aluminum cover with the two screws you removed earlier.
6 Plug the power cord into a 120 volt power source.
Note: For European and 240 volt applications, a step down transformer must be
used to provide 120 volts.
7 Using the pendant, move the power carriage through the entire range of motion
making sure there is no binding or jamming.
Note: When operating the power carriage with a bike on the dyno, make sure the
bike is in neutral.
Figure 3-50: Power Carriage Secured to Dyno
pendant
aluminum cover