User guide

Model 224 Above Ground Eddy Current Brake Installation and User Guide

CHAPTER 1

Introduction

1-4

PARTS LIST

The following table lists all of the parts included in the Eddy Current Brake

(P/N 72912001) Installation kit. Check your kit against the parts listed to make sure

you have received all of the parts. If any part is missing, contact Dynojet Technical

Support.

part number description quantity

21217500 Hood, Retarder Top 1

21217501 Hood, Retarder, Side 1

21217502 Hood, Retarder, Right 1

21217503 Hood, Retarder, Left 1

21228102 Blank Pass Through Cover 3

21228105 Double Hole Pass Through Cover 2

21228506 Cable Pass Through Cover 1

21626210 Z-Bracket (cable routing channel) 2

21917100 Foot 2

32355056 Bearing-Flange, 1.75”, 2-Bolt 1

32811195 O-Ring, 7/16 x 11/16”, #-205 1

35430899 Weight, 25 lb. 4

36580804 Screw-Set, 3/8-16 x 1/2”, W/Tlok 2

36708100 Nut, 1/2-13, Nylock-Hex 2

36721100 Nut, 5/8-11 UNC, Hex 1

36801080 Bolt, 1/2-13 x 1.25”, Flange-Hex 4

36923100 Washer, 5/16”, Hardened, Flat, Stl 12

37513200 Anchor, Redhead, 3/8” 2

37518200 Installation Tool, Redhead Anchor 1

37620844 Woodruff Key, 1/2 x 2.75”, 1622-1 1

49950030 Temp Sensor, 30-500C Max 1

61319001 Calibration Arm Assembly 1

62218130 Splined Shaft Assembly 1

62240130 Driveline Assembly, 7C, 224 Retarder 1

66411004 Theta-2 Controller - 240V -20A 1

65412004 PCB, Torque Cell Rev Switch, Loaded 1

66114002

66104001

Torque Module Sub-Assembly

Torque Module High Resolution Sub-Assembly

76950505 Torque Cell Assembly, 224 1

76950606 Cable, Input, 224 Torque Rev Sw 1

76950607 Cable, Output, 224 Torque Rev Sw 1

DM150-019-012 Bolt, 3/8-16 x 1”, Hex 10