Manual

Model 224 Pit Eddy Current Brake Installation and User Guide

CHAPTER 2

Load Cell Calibration

2-14

8 Install the calibration arm and weights using the bolts at the end of the calibration

arm.

Note: If you do not have enough room to use the bolt pattern closest to the end

of the calibration arm, use the bolt pattern in the center of the arm. Refer to

Figure 2-16 on page 2-15.

8a Secure the calibration arm to the eddy current brake by tightening the bolt

using the handle.

8b Gently place the weights on the calibration arm.

Note: Verify the calibration arm is not contacting the cover.

The calibration weights are very heavy. The weights must be set on the arm

gently or you will damage the load cell.

Figure 2-15: Install Calibration Arm and Weights Using the Bolt Pattern Closest to the End

weights

weight support

secure arm to brake by

tightening handle