User Manual

DynoWare EX+ Upgrade Installation Guide
DYNOWARE EX+ UPGRADE
Installation
6
6 Align the optical pickup with the tab on the dyno drum axle. Once aligned,
tighten the screws to secure the pickup card in place.
The optical pickup is very delicate. Be careful not to damage the optical pickup
during alignment.
Figure 8: Optical Pickup Alignment
7 Attach the small pickup cable to the Breakout board. The small pickup cable has
four wires which connect to the wiring block labeled DRUM 1.
• Red wire connects to R1
• White wire connects to W1
• Black wire connects to B1
• Ground wire connects to S1
8 Tighten the four screws in the top of the terminal block to secure the wires and
set the Breakout board aside.
Note: It is easier to attach the pickup cable wires to the Breakout board before
securing the board to the dyno.
Figure 9: Breakout Board Wiring—Pickup Card
pickup tab
optical pickup
pickup card
drum 1