Installation Guide Owner's manual

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
CHAPTER 2
Secure the Drum and Brake Module to the Pit Floor
2-16
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SECURE THE DRUM AND BRAKE MODULE TO THE PIT FLOOR
Dynojet recommends you secure your drum and brake modules to the pit floor in
your dyno room using concrete anchors. You will want to drill the holes and secure
the dyno before placing the covers on your dyno.
Note: You may wish to drill the holes for the carriage mounting plate and blower
mounts at this time. Refer to page 2-18 for carriage plate instructions and page 2-
22 for blower mounts and support arm instructions.
You will need the following parts:
• 37513200 Anchor, Redhead, 3/8" (6)
• 37518200 Installation Tool, Redhead Anchor
• DM150-002-007 Washer, 5/16", Flat (6)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (6)
1 Mark and drill each hole needed, as shown in Figure 2-11, to secure the drum and
brake modules to the pit floor.
2 Install the Red Head anchors. Refer to Appendix A for installation instructions.
Figure 2-11: Secure the Drum and Brake Module to Pit Floor
drill holes
drill holes
drill holes