Owner's manual

TORQUE MODULE INSTALLATION
Torque Module Installation
Version 2 Torque Module Installation and User Guide for Model 250i Dynamometers
1-11
4 Remove the twelve screws securing the cover and lift the cover off.
Figure 1-11: Remove Electronics Enclosure Cover
5 Add the torque module to the top of the dyno electronics. Refer to “Installing the
Torque Module” on page 1-12.
6 Leave the dyno electronics enclosure out. You will need to route the load cell
cable to the Torque Module later.
Figure 1-12: Inside the Electronics Enclosure
dyno electronics