Owner's manual

Torque Module Installation and User Guide for Model 250i Dynamometers
CHAPTER 1
Torque Module Installation
1-16
6 Plug the main power cord for the dyno in and place the breaker inside the power
distribution enclosure to the on position. Refer to page 1-3 for more information.
7 The green LED light on the Torque Module should now be on.
Figure 1-18: Attach Torque Module and Load Cell Cable
8 Replace the dyno electronics cover. Refer to Figure 1-11 on page 1-11.
9 Slide the dyno electronics enclosure back in the dyno. Refer to Figure 1-10 on
page 1-10.
load cell cable and port
do not attach at this time
green LED light
tie strap
torque module