Manualshelf

Owner's manual

ManualsBrandsDynojet ManualsEquipment250i: Torque Module
21222324252627282930
TORQUE MODULE INSTALLATION
Torque Module Installation
Version 2 Torque Module Installation and User Guide for Model 250i Dynamometers
1-17
REPLACING THE DYNO TOP COVER AND CARRIAGE
1 Secure the top cover to the dyno using the six 1/4-inch screws removed earlier.
Note: Dynojet recommends using a hardened 5/32-inch hex driver (such as
Snap-On FA5E) to remove the 1/4-inch screws. A standard allen key may round off
in the shallow screw head.
Figure 1-19: Replace the Top Cover