Owner's manual

TORQUE MODULE INSTALLATION
Introduction
Version 2 Torque Module Installation and User Guide for Model 250i Dynamometers
1-3
CONNECTING AND DISCONNECTING POWER TO THE DYNO
Many instructions in this guide will require you to connect or disconnect the power to
the dyno as part of the installation process. Use the following steps to connect and
disconnect power to the dyno.
1 Use the main breaker to turn power on and off to the dyno.
2 The main breaker is located inside the power distribution assembly.
3 Disconnect the power plug to ensure all power has been removed from the dyno
before performing certain installation procedures.
Figure 1-1: Main Breaker Location
main breaker
power plug