Owner's manual

Torque Module Installation and User Guide for Model 250i Dynamometers
CHAPTER 1
Load Cell Installation
1-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOAD CELL INSTALLATION
This section describes how to remove the top covers, install the load cell, and replace
the top covers.
REMOVING THE CARRIAGE AND DYNO TOP COVER
You will need to remove the tire carriage and top cover in order to route the load cell
cable to the dyno electronics.
1 Using a 5/32-inch allen wrench, remove the two button-head screws securing the
carriage screw support bracket and set aside.
2 Remove the support bracket and set aside.
Figure 1-2: Remove the Support Bracket
screws
support
bracket
carriage screw
belleville washers