Installation Guide User guide

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
INDEX
Index-iv
S
secondary inductive pickup 5-7
setting tool A-3
specifications 1-5–1-8
starter
routing cable 2-33
using 4-5
starter brace 2-9, 2-10
status indicator 4-3, 4-6
support arm
anchor placement 2-16
installing 2-17
remove from crate 2-2
T
technical support 1-3
temperature sensor cable
routing
wiring to breakout board 2-36
testing voltages B-4, B-9
theta controller
dip switches D-2
power adjustment D-2
power line frequency D-3
power line voltage D-3
replace fuses 4-10
wiring to breakout board 2-36
tie-down straps 1-8
tie-downs 5-3
tire carriage 2-13–2-15, 5-2
carriage plate 2-13
installing 2-15
remove from crate 2-2
W
warnings v
weight 1-5
wheel clamp
closing 4-7
installing 3-26–3-27
maintenance 4-9
opening 4-7
routing cable 2-28–2-31
testing 2-38, 3-27
troubleshooting 4-9
using 4-6
width 1-5
WinPEP
finding manuals on 3-1
wiring breakout board
jumpers 2-36
pickup card cable 2-36
temperature sensor cable 2-36
theta controller cable 2-36
Y
your dyno room 1-3
equalizer box 1-4
exhaust extraction 1-4
fire suppression 1-4
intake air fan 1-4
noise control 1-4
Z
zip tube 2-46