Installation Guide User guide

ACCESSORIES
High Pressure Blower
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
3-23
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HIGH PRESSURE BLOWER
The high pressure blower supplies air to cool the bike’s engine. This section will walk
you through the blower installation procedures.
PARTS LIST
The following table lists all of the parts included in the High Pressure Blower
Assembly (P/N 76722003). Check your kit against the parts listed to make sure you
have received all of the parts. If any part is missing, contact Dynojet Technical
Support.
part number description quantity
26215520 Washer, 1.87 x 1.25 IDx .12THK 4
26215521 Washer, 1.87x1.25 IDx .25THK 2
35521420 Cap Plug, 1-3/4 x 1/2", Black 8
35712991 Clamp Lever, 3/8-16 x 3/4" 4
35712992 Clamp Lever, 3/8-16 x 1-1/2" 2
42303160 Cable-Retractable, 3-Cond, 16-3 1
43814131 AC Plug, Cord, Hi-Currency, 16A/250V 2
61328101 Blower Housing Assembly-Generic 2
63413001 Pivot Arm-Top Assembly 2
63413004 Lower Blower Arm Assembly 2