Installation Guide Owner manual

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
CHAPTER 3
Wheel Clamp
3-18
2 Place the wheel clamp on the carriage. Align the four holes on the wheel clamp
with the holes on the carriage.
3 Secure the wheel clamp to the carriage using four 3/8-16 x 1-inch bolts,
four 5/16-inch lock washers, and four 5/16-inch flat washers.
Figure 3-20: Secure the Wheel Clamp to the Carriage
4 Bring the wheel clamp cable (three-pin connector) from the cable track over to
the wheel clamp. This cable was routed on page 2-38.
5 Install the wheel clamp cable strain relief to the side of the wheel clamp.
6 Plug the wheel clamp cable into the connector on the wheel clamp motor.
7 Replace the wheel clamp cover.
Figure 3-21: Secure the Strain Relief and Cable
PD131
PD132
wheel clamp cable
strain relief
cable track
wheel clamp
motor connector