Installation Guide Owner manual

POWER REQUIREMENTS AND INSTALLATION

Locations Using 50 Hz Power (Locations other than North America and Japan)

Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide

B-9

TESTING FOR CORRECT VOLTAGES

You must test the receptacle for proper voltages before the dyno is connected to the

outlet.

Using a voltmeter that is capable of measuring AC voltage, measure between the

points listed below and verify that the correct voltages are present.

Figure B-3: Test the Wall Receptacle

probe 1 probe 2 desired voltage measurement

1 3 220V to 250V

2box<5V