User Manual

Pre-Installation Guide for Model 200i/250i, 200iP/250iP, 250iX, and 250iPX Motorcycle Dynamometers
DYNO PRE-INSTALLATION INFORMATION
Model 200i/250i Dynamometer
12
GROUND HOOK PLACEMENT—MODEL 200I/250I DYNO
You may wish to install additional ground hooks (included with your dyno) for
securing the motorcycle. Using Figure 5 as a guide, place the ground hooks in a
location that works best for your dyno application.
1 Using the ground hook as a template, mark and drill each hole needed to secure
the ground hooks to the floor.
2 Install the Red Head anchors. Refer to Appendix A for installation instructions.
3 Secure each ground hook to the floor using two 3/8-16 x 1-inch hex bolts, two
5/16-inch flat washers, and two 3/8” lock washers.
Figure 5: Ground Hook Placement—Model 200i/250i Dynos