User Manual

DYNO PRE-INSTALLATION INFORMATION
Model 200iP/250iP Dynamometer
Version 3 Pre-Installation Guide for Model 200i/250i, 200iP/250iP, 250iX, and 250iPX Motorcycle Dynamometers
13
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MODEL 200IP/250IP DYNAMOMETER
The following specifications and requirements will help you set up your dyno area
and verify you have met the requirements necessary to operate your dyno safely.
PIT SPECIFICATIONS
Before proceeding, take a moment to look over the pit dimensions and requirements
for your in ground dyno. Refer to the pit dimensions (P/N 98229102) you received
from your salesman for more detailed specifications.
Note: The pit must be provided with exhaust ventilation at a rate of not less than
1CFM per ft.
2
of floor area (26CFM for the 250iP pit) taken from a point 300 mm
(12 in.) off the floor of the pit at all times that the building is occupied or when
vehicles are parked over this area.
CHASSIS SPECIFICATIONS
description specifications
Length
with standard carriage allow 304.80 cm (120.00 in.)
with extended carriage allow 355.60 cm (140.00 in.)
pit covers 137.16 cm (54.00 in.)
Height
from top of pit to drum guard 5.40 cm (2.125 in.)
from top of pit to top of carriage 50.64 cm (16.00 in.)
from pit floor to top of dyno frame 45.72 - 46.67 cm (18.00 - 18.375 in.)
Width
model 200iP 105.03 cm (41.35 in.)
model 250iP 179.07 cm (70.50 in.)
pit covers 208.28 cm (82.00 in.)
Weight
model 200iP drum module/crated dyno 725 kg (1,600 pounds)/817 kg (1,800 pounds)
model 250iP retarder module/crated dyno 953 kg (2,100 pounds)/1,043 kg (2,300 pounds)
Drum
diameter 45.72 cm (18.00 in.)
width 50.80 cm (20.00 in.)
Frame structural steel channel and angle
Maximum Horsepower 373 KW (500 HP)
Maximum Speed 322 KPH (200 MPH)
Maximum Motorcycle Length (front of front
wheel to center of rear wheel)
standard carriage 213.00 cm (84.00 in.)
extended carriage 256.54 cm (101.00 in.)