User Manual

DYNO PRE-INSTALLATION INFORMATION
Model 250iX Dynamometer
Version 3 Pre-Installation Guide for Model 200i/250i, 200iP/250iP, 250iX, and 250iPX Motorcycle Dynamometers
17
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MODEL 250IX DYNAMOMETER
The following specifications and requirements will help you set up your dyno area
and verify you have the requirements necessary to operate your dyno safely.
CHASSIS SPECIFICATIONS
description specifications
Length
with standard carriage allow 271.78 cm (107.00 in.)
with extended carriage allow 322.58 cm (127.00 in.)
with ramp in down position add 370.84 cm (146.00 in.)
Height
to top of dyno cover 45.97 cm (18.10 in.)
Width
model 200iX 200.69 cm (79.00 in.)
model 250iX 274.32 cm (108.00 in.)
ramp 185.42 cm (73.00 in.)
Weight
model 200i dyno/crated dyno 725 kg (1,600 pounds)/771 kg (1,700 pounds)
model 250i retarder module/crated 953 kg (2,100 pounds)/1,089 kg (2,400 pounds)
200iX/250iX drum module/crated 136 kg (300 pounds)/363 kg (800 pounds)
Drum
diameter 45.72 cm (18.00 in.)
width 50.80 cm (20.00 in.)
diameter, 200iX/250iX 45.72 cm (18.00 in.)
width, 200iX/250iX 55.88 cm (22.00 in.)
Frame structural steel channel and angle
Maximum Horsepower 500 HP (373 KW)
Maximum Speed 200 MPH (322 KPH)
Maximum Motorcycle Length (front of
front wheel to center of rear wheel)
standard carriage 213 cm (84.00 in.)
extended carriage 256.54 cm (101.00 in.)
Remote Switches remote software control