Installation Guide User Manual

MODEL 200IX/250IX UPGRADE
Dyno Preparation
Version 1 Model 200iX/250iX Upgrade Installation Guide
1-7
REMOVING THE HIGH PRESSURE BLOWER ASSEMBLIES
1 Unplug each high pressure blower power cord from the dyno chassis.
2 Remove the clamp lever securing the blower arm assembly to the dyno and
discard. Do this for both blower assemblies.
3 Lift the blower and arm assembly from the dyno and set aside. Do this for both
blower assemblies.
Note: Both blower assemblies must be removed in order to replace the lower
blower arm. A new lower blower arm is needed to work with the new upgrade tie-
downs.
Figure 1-4: Removing the Blower Assemblies
blower and arm
assembly
power cord
from blower
clamp lever