Installation Guide User Manual

MODEL 200IX/250IX UPGRADE
Dyno Preparation
Version 1 Model 200iX/250iX Upgrade Installation Guide
1-9
REMOVING THE DYNO PANELS
1 Push the wires, from the monitor stand, back through the cable pass through.
Note: Perform this step only if the monitor stand was installed on the right side of
the dyno.
2 Remove the five screws securing the top panel to the dyno and set aside. Remove
the top panel and set aside.
3 Disconnect the fan power cable from the power socket on the inside of the side
panel.
4 Remove the eight screws securing the drum side panel to the dyno and set aside.
Remove the panel and set aside.
5 Remove the twelve screws securing the side panel to the dyno and set aside.
Remove the side panel and set aside.
Figure 1-6: Removing the Dyno Panels
top panel
side panel
drum side
panel
cable pass
through
fan power
socket