Installation Guide User Manual

424 LINX INSTALLATION

Dynojet Logo Panels and Pit Covers

Version 6 Linx Installation for Model 424 Automotive Dynamometers

7 Remove the two 3/8-16 x 1.5-inch flange hex bolts, washers, and nuts securing the

rear deck brace to the mounting bracket. Set the hardware aside.

8 Remove two 3/8-16 x 1.5-inch flange hex bolts securing the rear deck brace

mounting bracket to the dyno. Set the hardware aside.

9 Remove the rear deck brace mounting bracket and set aside.

Figure 4: Remove the Rear Deck Brace Mounting Bracket

REMOVING THE PIT COVERS—IN GROUND

If present, remove any pit covers on this side of the dyno.

XD004

XD005

rear deck brace

mounting bracket

rear deck brace