Installation Guide User Manual

Linx Installation for Model 424 Automotive Dynamometers
424 LINX INSTALLATION
Inner Mounting Plate Installation
10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INNER MOUNTING PLATE INSTALLATION
Use the following instructions to install the moveable dyno and stationary dyno inner
mounting plates.
You will need the following parts:
• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (2)
• 36923100 Washer, 3/8", Flat (18)
• 61300024 Inner Mounting Plate, Stationary Dyno
• 61300027 Inner Mounting Plate, Moveable Dyno
• DM150-011-004 Nut, 3/8-16, Hex (2)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (16)
INSTALLING THE INNER MOUNTING PLATE—MOVEABLE DYNO
1 Secure the inner mounting plate to the moveable dyno using eight 3/8 x 1-inch
bolts and eight 3/8-inch flat washers.
Note: For above ground installations, use only six 3/8 x 1-inch bolts and
six 3/8-inch flat washers.
Figure 5: Secure the Inner Mounting Plate to the Moveable Dyno
XD006
for in ground
installations only
inner mounting plate