Installation Guide User Manual

Linx Installation for Model 424 Automotive Dynamometers

424 LINX INSTALLATION

Pulley Mounting Plates and Outer Bearings Installation

INSTALLING THE MOVEABLE DYNO PULLEY OUTER BEARING, BEARING MOUNTING PLATE,

AND LOWER PULLEY MOUNT

1 Secure the outer moveable dyno pulley bearing to the moveable dyno pulley

bearing plate using four 9/16-12 x 2-inch bolts, four 9/16-inch flat washers, and

four 9/16-inch nuts. Slide this assembly onto the moveable dyno pulley outer

shaft.

Figure 18: Install the Outer Moveable Dyno Pulley Bearing and Bearing Plate

2 Place the lower moveable dyno pulley mount (P/N 61300026) under the

moveable dyno pulley and loosely secure the mount to the inner plate using

five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.

3 Loosely secure the pulley mount to the moveable dyno pulley bearing plate using

three 3/8-16 x 1-inch bolts and three 3/8-inch flat washers.

Figure 19: Secure the Pulley Mount Under the Moveable Dyno Pulley

XD057

moveable dyno

puller bearing

moveable dyno pulley

bearing plate

moveable dyno

pulley

XD058

pulley mount

P/N 61300026