Installation Guide User Manual

424 LINX INSTALLATION

Pulley Mounting Plates and Outer Bearings Installation

Version 6 Linx Installation for Model 424 Automotive Dynamometers

INSTALLING THE UPPER MOVEABLE DYNO AND IDLER PULLEY MOUNTS

1 Place a lower stationary dyno pulley mount (P/N 61300023) over the moveable

dyno pulley and loosely secure the mount to the inner plate using

five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers (one of the holes in the

pulley mount is not used).

2 Loosely secure the pulley mount to the moveable dyno pulley bearing plate using

five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.

Figure 20: Secure the Pulley Mount Over the Moveable Dyno Pulley

XD059

pulley mount

P/N 61300023