Installation Guide User Manual

Linx Installation for Model 424 Automotive Dynamometers

424 LINX INSTALLATION

Pulley Mounting Plates and Outer Bearings Installation

3 Place the upper moveable dyno pulley mount (P/N 61300025) over the idler

pulley and loosely secure the mount to the inner plate using five 3/8-16 x 1-inch

bolts and five 3/8-inch flat washers.

4 Loosely secure the pulley mount to the idler pulley bearing plate using

five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.

5 Loosely secure the pulley mount to the movable dyno pulley bearing plate using

two 3/8-16 x 1-inch bolts and two 3/8-inch flat washers.

6 While applying upward pressure to support the shaft and pulley, tighten all the

bolts.

Figure 21: Secure the Pulley Mount Over the Idler Pulley

XD060

pulley mount

P/N 61300025